I've been using Protel 99se for several months and regularly import dxf
files not only from AutoCAD, but from SolidWorks as well, without the
problems you are describing - so I don't think the release is the problem.
During the time I've described, I have installed service packs 5 and 6, so
it isn't that.
Mike Crist
Newport Corp.
[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net