great tip, I never realized that!
thanks
Dennis Saputelli
"Hamid A. Wasti" wrote:
> It is a bad idea to use an inside radius same as your router bit radius. This
> requires the router to come to a complete stop and then start moving at 90
> degrees. There will invariably be some chatter and the router will cut into the
> sides. It is better to make a minimum radius larger than the router radius so
> the cut is programmed as an arc which will give a lot better results.
>
> Hamid
>
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
