It does seem to be light today, but I did see your post, so something is
working!
I have a sort of procedural question I'd like to throw out to the group. I
have been using Protel 99 for a couple of years now both for schematic entry
and the subsequent PCB creation. I have always created netlist from the SCH
and then gone into the PCB (which I manually place) and load nets. I also
use this procedure if I make a change later in the SCH. I know about the
synchronize SCH and PCB function but have been wary of it, the one time I
tried it, it seemed to have a mind of its own. Is the way I'm doing it
totally inefficient or is this a common practice?
Thanks,
Greg Olson
DSX Access Systems, Inc.
----- Original Message -----
From: "Coleman, Tim" <[EMAIL PROTECTED]>
To: "Multiple recipients of list proteledausers"
<[EMAIL PROTECTED]>
Sent: Thursday, February 15, 2001 11:09 AM
Subject: [PROTEL EDA USERS]: Anyone there?
> ??
>
> Just checking, I've seen only a few posts from the forum today and that
was
> this morning.
>
>
> Time is 5:09PM GMT
>
>
>
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> * This message sent by: PROTEL EDA USERS MAILING LIST
> *
> * Use the "reply" command in your email program to
> * respond to this message.
> *
> * To unsubscribe from this mailing list use the form at
> * the Association web site. You will need to give the same
> * email address you originally used to subscribe (do not
> * give an alias unless it was used to subscribe).
> *
> * Visit http://www.techservinc.com/protelusers/subscrib.html
> * to unsubscribe or to subscribe a new email address.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This message sent by: PROTEL EDA USERS MAILING LIST
*
* Use the "reply" command in your email program to
* respond to this message.
*
* To unsubscribe from this mailing list use the form at
* the Association web site. You will need to give the same
* email address you originally used to subscribe (do not
* give an alias unless it was used to subscribe).
*
* Visit http://www.techservinc.com/protelusers/subscrib.html
* to unsubscribe or to subscribe a new email address.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
________________________________________________________
To leave the EDAFORUM discussion list, send a email with
'leave edaforum' in the body to '[EMAIL PROTECTED]'
More Information : http://www.dolist.net
