Watch out for the ORCAD port interpretation being clicked on under
Tools/preferences. I have see this play with ports in this manner.

Fabe

-----Original Message-----
From: Brooks,Bill [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, April 17, 2001 1:48 PM
To: 'Protel EDA Forum'
Subject: [PEDA] problem w/ ports on Protel Schematic Service pack 6


Another weird problem.... 

I have a schematic that was edited by another user here that looks fine on
his machine... but when I pull it up the ports all change in length and are
not connected properly. Anyone seen this effect? Maybe I have some setting
that's wrong? or he does? can anyone clarify what's going on? I pull the
same file up in 98 and it looks fine!!!
Whets happening here?

Bill Brooks 
PCB Design Engineer 
DATRON WORLD COMMUNICATIONS INC.
3030 Enterprise Court 
Vista, CA 92083 
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510 
mailto:[EMAIL PROTECTED] 
IPC Designers Council, San Diego Chapter 
http://www.ipc.org/SanDiego/
http://home.fda.net/bbrooks/pca/pca.htm



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to