At 09:18 AM 4/17/01 -0700, Brooks,Bill wrote:

>I have a schematic that was edited by another user here that looks fine on
>his machine... but when I pull it up the ports all change in length and are
>not connected properly. Anyone seen this effect? Maybe I have some setting
>that's wrong? or he does? can anyone clarify what's going on? I pull the
>same file up in 98 and it looks fine!!!
>Whets happening here?

Probably Tools/Preferences/OrCAD_Ports is checked. When you load an OrCAD 
schematic, I think it is automatically set; and then it stays checked until 
you uncheck it.

[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to