I want to thank everyone for the information. The Eagle file was in inches,
and when I imported the file into Protel I left the default's on (which
measured everything in mils). Taking Ian's advice I reimported the file in
mm and everything measured out right.
Thank you,
Ted
-----Original Message-----
From: Jim McGrath [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, May 01, 2001 4:22 PM
To: Protel EDA Forum
Subject: Re: [PEDA] importing DWG files
Ted,
Is the Eagle file in mm and the Protel set to inches? I have seen this cause
a
problem.
Regards,
Jim
Ted Tontis wrote:
> I am trying to import a DWG file in to Protel. I have a board in Eagle and
I
> am trying to import the board out line and component placement into
Protel.
> When I import the file the scale is lost, The board increases in size. Is
> there a way to import the drawing in the same scale it was originally
drawn
> in?
>
> Thank you,
>
> Ted Tontis
> Engage Networks Inc.
> [EMAIL PROTECTED]
> PH 414.273.7600 Ext. 7607 <http://www.engagenet.com>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
