Tom,

I had the same problem, what you need to do is use
place line instead.

Darren Moore


> When I'm placing tracks on a mechanical layer and change the 
> width of the track (using TAB) the "look ahead" segment of 
> the track changes to one of the signal layers.
> 
> It  is not possible to change the layer back by using "+", 
> "-" or "*" (they cycle through the signal layers only). So I 
> have to stop placing the track and select the mechanical 
> layer tab and then start again. 
> 
> Is there any way to stop this annoying behaviour?
> 
> Thanks,
> 
> Tom.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to