When I'm placing tracks on a mechanical layer and change the width of the
track (using TAB) the "look ahead" segment of the track changes to one of
the signal layers.

It  is not possible to change the layer back by using "+", "-" or "*" (they
cycle through the signal layers only). So I have to stop placing the track
and select the mechanical layer tab and then start again. 

Is there any way to stop this annoying behaviour?

Thanks,

Tom.

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to