Hi All

Im sure this one has been touched before.

I need to create two strips on either end of a board that are completely
void of components. Its ok to place traces in these areas but not
components.

How do I set up a design rule to check for violations?

I could draw keep outs but that would keep out traces as well - which is
what I dont want.

Thanks in Advance

Wayne Trow
Gallagher Group LTD
Hamilton
New Zealand

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to