Create a Room Definition (design rules/placement).

> -----Original Message-----
> From: Wayne Trow [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, 1 November 2001 11:55 AM
> To: [EMAIL PROTECTED]
> Subject: [PEDA] Clearance from edge of board
> 
> 
> Hi All
> 
> Im sure this one has been touched before.
> 
> I need to create two strips on either end of a board that are 
> completely
> void of components. Its ok to place traces in these areas but not
> components.
> 
> How do I set up a design rule to check for violations?
> 
> I could draw keep outs but that would keep out traces as well 
> - which is
> what I dont want.
> 
> Thanks in Advance
> 
> Wayne Trow
> Gallagher Group LTD
> Hamilton
> New Zealand
> 

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to