.......and change the room definition properties "keep components out" - via
right mouse click on room in question, or through design rules > placement >
room definition.


----- Original Message -----
From: "Thomas" <[EMAIL PROTECTED]>
To: "'Protel EDA Forum'" <[EMAIL PROTECTED]>
Sent: Thursday, November 01, 2001 2:08 PM
Subject: Re: [PEDA] Clearance from edge of board


> Create a Room Definition (design rules/placement).
>
> > -----Original Message-----
> > From: Wayne Trow [mailto:[EMAIL PROTECTED]]
> > Sent: Thursday, 1 November 2001 11:55 AM
> > To: [EMAIL PROTECTED]
> > Subject: [PEDA] Clearance from edge of board
> >
> >
> > Hi All
> >
> > Im sure this one has been touched before.
> >
> > I need to create two strips on either end of a board that are
> > completely
> > void of components. Its ok to place traces in these areas but not
> > components.
> >
> > How do I set up a design rule to check for violations?
> >
> > I could draw keep outs but that would keep out traces as well
> > - which is
> > what I dont want.
> >
> > Thanks in Advance
> >
> > Wayne Trow
> > Gallagher Group LTD
> > Hamilton
> > New Zealand
> >
>


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to