Just to be a tiny bit more complete, under some display conditions and 
object can appear, and then when you edit or move it, it disappears. This 
happens when the layer that the object is on is not enable, but the object 
was made visible because of some operation that highlights primitives on 
other layers or something like that.

For a mounting hole, make sure that multilayer is enabled. Also make the 
pad a bit bigger than the hole (you are going to need clearance for the 
mounting hardware, and that is a one way to do it, the other way is by 
design rule for mounting holes), though I think it should still show if 
holes are enabled and the holes are a contrasting color.
[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to