Dwight Harm wrote:
> I'd tend to agree with Ian.
Me too!
But what comes to my mind is an alternative method (though I
actually never did it myself): What's about a mixed
rigid/flex PCB? That could keep the single project while
offering a "dual slot" mounting. Don't know if the costs for
rigid/flex increase over the additional
connector/cable/test/assembly costs in your project.
Regards, Emanuel
--
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
MPL AG www.mpl.ch
Emanuel Zimmermann [EMAIL PROTECTED]
Manager R&D Phone: +41 (0)56 483 34 34
Taefernstrasse 20 Fax: +41 (0)56 493 30 20
CH-5405 Daettwil
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
