Just had this happen to me (see below). I moved the keepout tracks away from the polygon, repoured the polygon, moved the keepout tracks back into position, repoured again, this time keepouts are recognized?!
Duane Foster > -----Original Message----- > From: Wayne Trow [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, February 12, 2002 11:39 AM > To: Protel EDA Forum > Subject: Re: [PEDA] Serious Bug: Polygons still connecting to > pads after > the net has been changed to something other then the polygon net name. > > Brad, > > Ive had this problem with keepout tracks. > > I place the track to control where the polygon will pour therefore the > polygon is there when I place the track hence the track picks > up the net > name. > I edit the porperties of the track and change from GND > (usually) to No_Net > and check keepout. The online drc then shows the error as it should. > > BUT > > If I repour the polygon it ignores the "different net" > keepout and acts as > if the keepout isn't even there. > > Similar but different problem. > > Thanks > > Wayne Trow > PCB Design Technician * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *