Y' all havent heard my response yet because e Im trying to visualize if using one paste screen for alternating top and bottom panels will work. ( it was the best expanation I heard yet why anyone would want to mirror a design) It sounds good but Im still trying to visualize it in my limited scope. I need to cut some cardboard up and try it. I dont want anyone getting any bright ideas we are just now straighting out backward designs from the past.....Im chomping on it still. And yes I have a backward board sitting my desk
Mike Reagan ----- Original Message ----- From: Brad Velander <[EMAIL PROTECTED]> To: 'Protel EDA Forum' <[EMAIL PROTECTED]> Sent: Thursday, February 28, 2002 3:04 PM Subject: Re: [PEDA] Flipped on panel Paired Mechanical layers (ex Inversio n ...) > Dennis, > this answer is colored by the fact that we don't actually do > assembly here. > > First we typically use thin laminates 0.008" - 0.0031" with a > majority in the 0.020 - 0.025" range. Our tabs are just solid tabs, no > drills to allow easier breaks. Our tab width is typically about 0.200" > material in the tab at the centers. Because we are using such thin laminates > they are usually just cut off with an exacto knife. > > Probably not a lot of help to you, but that is our use. > > Sincerely, > Brad Velander. > > Lead PCB Designer > Norsat International Inc. > Microwave Products > Tel (604) 292-9089 (direct line) > Fax (604) 292-9010 > email: [EMAIL PROTECTED] > http://www.norsat.com > > See us at Booth 323 at Satellite 2002 in Washington, DC March 6-8. > > > > -----Original Message----- > From: Dennis Saputelli [mailto:[EMAIL PROTECTED]] > Sent: Thursday, February 28, 2002 9:12 AM > To: Protel EDA Forum > Subject: Re: [PEDA] Flipped on panel Paired Mechanical layers (ex > Inversio n ...) > > > just curious, what means of separating the finished panels do you use? > tabs with little mouse bit holes? > .1" route slots between? > how do you clean up the rough parts? > > Dennis Saputelli > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
