Dennis,
        this answer is colored by the fact that we don't actually do
assembly here.

        First we typically use thin laminates 0.008" - 0.0031" with a
majority in the 0.020 - 0.025" range. Our tabs are just solid tabs, no
drills to allow easier breaks. Our tab width is typically about 0.200"
material in the tab at the centers. Because we are using such thin laminates
they are usually just cut off with an exacto knife.

        Probably not a lot of help to you, but that is our use.

Sincerely,
Brad Velander.

Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel   (604) 292-9089 (direct line)
Fax  (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com

See us at Booth 323 at Satellite 2002 in Washington, DC March 6-8.



-----Original Message-----
From: Dennis Saputelli [mailto:[EMAIL PROTECTED]]
Sent: Thursday, February 28, 2002 9:12 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Flipped on panel Paired Mechanical layers (ex
Inversio n ...)


just curious, what means of separating the finished panels do you use?
tabs with little mouse bit holes? 
.1" route slots between?
how do you clean up the rough parts?

Dennis Saputelli

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to