Hi Mike When you edit the pad properties, on the "advanced" tab there is a "plated" checkbox. If you want unplated holes/pads, you need to uncheck this option.
non-PTH holes are designated separately in the drill table (.legend). Regards, Brendon. ----- Original Message ----- From: "Robison Michael R CNIN" <[EMAIL PROTECTED]> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]> Sent: Friday, April 05, 2002 8:25 AM Subject: [PEDA] drill hole with no plating ? > hello, > > i've been using a thru-hole pad with the pad smaller > than the hole for a nonplated drill hole. i thought > i was being slick. now i've had two different board > shops chewing my rear for it in a one week period. > > how do i properly designate an unplated hole using > protel? > > thank you, miker * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
