hello,

i've been using a thru-hole pad with the pad smaller
than the hole for a nonplated drill hole.  i thought 
i was being slick.  now i've had two different board 
shops chewing my rear for it in a one week period.

how do i properly designate an unplated hole using
protel?  

thank you, miker

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to