OK, I feel like an idiot for asking this question, but I'll use the excuse that I'm only an occasional PCB designer. I mainly write firmware.
I have placed a few pads on my PCB with the following properties: X size: 0 Y size: 0 Round Hole size 147 mil Multi-layer Not plated These are supposed to be mounting holes. I get annular ring violations on these pads. Should I not be using pads for mounting holes? Protel 99 SE sp6. Thanks, Matt __________________________________________________ Do You Yahoo!? LAUNCH - Your Yahoo! Music Experience http://launch.yahoo.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *