i've got a 144 pin PQFP 0.5mm pitch
there are only a small number of connected pins, maybe a dozen or so
excluding power
i am thinking about deleting a lot of unused pads to possibly open up
top side routes and reduce inspection and bridging concerns
am i crazy?
do you think the leads will short thru the solder mask to traces below?
is this good practice even if i don't run traces there, i.e. will it
solder and align properly with missing pads?
Dennis Saputelli
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
