I would use a ribbon cable that was previously suggested, or use a
flex circuit. Running traces to the edge of a board would cause lamination
and corrosion problems. If the copper is run through the tab and then the
board is snapped apart that copper track will be exposed on the edge. Also
there would be no ground or power plane under the tracks, unless it is not a
multilayer board
        After removal of the unneeded card it could be possible for those
tracks to become an unwanted antenna.

Regards,

Ted

************************************************************************
* Tracking #: EDA8C6609E34194CA37E9C3B230CC8E9EB73FAA0
*
************************************************************************

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to