That will really confuse 'em. :)
> -----Original Message----- > From: Dennis Saputelli [mailto:[EMAIL PROTECTED]] > Sent: Thursday, September 26, 2002 7:05 PM > To: Protel EDA Forum > Subject: Re: [PEDA] Question about track placement > > > nah > it's easier i think assuming it lands on a pad or something > w/ the right net > > just do as below > then cut it (with a good ref point) and paste it back > the whole thing will acquire the net of the pad it lands on > > or paste on something w/ the right net to pick the net up and > then move selection out into the air if you want > > Dennis Saputelli > > Tony Karavidas wrote: > > > > First deselect everything: Use the keys X A > > Then, select all of the zigzag trace. One way is to chose > > Edit-Select-ConnectedCopper.( E S P ) and click on one > section of it. > > The whole thing will turn white. Once it is all selected, edit one > > segment, assign the net name, click Global, and under > "Attributes To > > Match By" change the Selection to "Same" and press OK > > > > That's it. > > > > > -----Original Message----- > > > From: Anand Kulkarni [mailto:[EMAIL PROTECTED]] > > > Sent: Thursday, September 26, 2002 6:26 PM > > > To: PROTEL USER Group > > > Subject: [PEDA] Question about track placement > > > > > > > > > Hi everybody, > > > I have a question about the tracks in PROTEL. > > > > > > Suppose I have a track that runs in a zig-zag manner and is quite > > > long. > > > > > > Now what do I do to assign this track to a net? > > > > > > When I click on the track only a segment is selected. > > > And then in the properties of that track segment I can > assign a net > > > to it. > > > > > > But then do I have to do this for each and every segment of that > > > long track. I think there is a better way of doing what I want to > > > do. > > > > > > I'd greatly appreciate any suggestions, > > > please do reply, > > > > > > thanks and regards, > > > Anand Kulkarni > > > > > > > > > > > > ____________________________________________________________ > > > Tired of all the SPAM in your inbox? Switch to LYCOS MAIL PLUS > > > http://www.mail.lycos.com/brandPage.shtml?pageId=plus > > > > > -- > ______________________________________________________________ > _____________ > www.integratedcontrolsinc.com Integrated Controls, Inc. > tel: 415-647-0480 2851 21st Street > fax: 415-647-3003 San Francisco, CA 94110 > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
