Jun, Generally all that you can do in Protel are the flipping and turning you can do with a completed pwb with your hands. If you wish to move left to right and right to left, while keeping the components on the top side, you'll need to re-route. John
Jun Gong wrote: > Hi, Any one knows how to flip a board in Protel? > > I want to turn the direction of a pre-routed PCB ( the left side will be at > right side and right side will be at the left, just like I hold a piece of > PCB board in hand and turn it ). > > I selected the PCB board, then press X key, Protel prompts that it will flip > the board in the same layer, so wires are kept in the original layer and > compoent footprints are flipped but keep in the original layer. > > I can not use "L" key, because a lot of wires and components are selected. > > Anyone has a solution? > > Thanks a lot. > > Jun -- >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >John M. Cardone Electro-Mechanical Dsgn. Engr. Grp. >M/S 278-100 Mechanical Engineering Section, 352 >4800 Oak Grove Dr. NASA / Jet Propulsion Laboratory >Pasadena, Ca 91109 MailTo:[EMAIL PROTECTED] >Tel: 818.354.5407 Fax: 818.393.6400 >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/proteledaforum@techservinc.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *