In a message dated 12/9/2002 10:49:23 PM Eastern Standard Time, [EMAIL PROTECTED] writes:
> I have a problem generating gerber files for my 5 layer board. I get a > whole lot of 0 mil holes > reported when I look at the gerber files however there are none on the > board apart from surface > mount parts which don't usually get reported. Strange thing is that when > I change something > the holes reported as 0 mil move around the board. Anyone seen this? > More importantly, anyone > know what causes it? Any help would be greatly appreciated. > > It sounds like you might have some pads set to Multilayer with a 0 mil hole diameter. I believe it's the layer selection, not the hole diameter, which determines whether or not the pad shows up in the drill file. Steve Hendrix * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
