hi there, this is a general PC board layout design question as opposed to a protel specific question - i hope noone minds too much

my question is this - i have a double sided board with ground fills on both sides - what is the best way to go about connecting these? the board is an audio A/D card (though not a fancy super high fidelity design by any means)

scattering a bunch of vias all over the place? or only connecting at a few key points ?

thanks for any advice/pointers to more information on the subject

-rimas



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to