At 18/07/2003 10:22, Peter Moreton wrote:
...
However, I noticed today that when I start the Autorouter, there is
quite a bit of copper already on the PCB, from previous sessions.


Peter,
I've had a similar problem. What I did: selected one of the remaining bits of track, edited the properties globally to select the tracks and then hit Ctrl-del.
This effectively cleared all tracks from the board.
Make sure you disable all non-copper layers beforehand, or you'll probably lose your component and board outlines too.......


Hope this helps.
Take carwe,
Leo



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to