Jim and Ian,

Thanks for the replies.  So, when you installed the program, did you do the
standard installation or just copy the "Client" sub-directory over to the
Win2K disk?  The "Client" directory is designed to let you run the program
from the CD, if you desire, without installing the software on disk.  I went
that route since I wasn't sure how the installer would handle NT, and
because I didn't want it copying over lots of old DLLs that might cause
problems down the line.

    Thanks,
    PeterM

----- Original Message ----- 
From: "Jim Walker" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 09, 2003 12:15 AM
Subject: Re: [PEDA] Advanced Schematic on Win2k?


>
> I am running 3.4 on win2k. I had lots of problems upgrading my computer
> (Sony laptop) to win2k but installing the protel software was not one of
> them.
>
> Jim Walker
> Walker Power Design, Inc.
> [EMAIL PROTECTED]


----- Original Message ----- 
From: "Ian Capps" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 09, 2003 12:28 AM
Subject: Re: [PEDA] Advanced Schematic on Win2k?


>
> Hi Peter
>
> I have EDA Client 3.0 on WIN 2K without hassles.
>
> Ian Capps




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to