Peter,

As I recall, I just inserted the disk(s) and clicked the appropriate squares for a standard installation. When I then went to use it, a message popped up stating some limitation on usage until I unlocked it. I went to the help - about screen to access the unlock code entry etc. and it worked the same as it did many years ago on win95 or 98.

Jim Walker
Walker Power Design, Inc.
877 281-7483

Peter Montgomery wrote:

Jim and Ian,

Thanks for the replies.  So, when you installed the program, did you do the
standard installation or just copy the "Client" sub-directory over to the
Win2K disk?  The "Client" directory is designed to let you run the program
from the CD, if you desire, without installing the software on disk.  I went
that route since I wasn't sure how the installer would handle NT, and
because I didn't want it copying over lots of old DLLs that might cause
problems down the line.

    Thanks,
    PeterM

----- Original Message ----- From: "Jim Walker" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 09, 2003 12:15 AM
Subject: Re: [PEDA] Advanced Schematic on Win2k?




I am running 3.4 on win2k. I had lots of problems upgrading my computer
(Sony laptop) to win2k but installing the protel software was not one of
them.

Jim Walker
Walker Power Design, Inc.
[EMAIL PROTECTED]



----- Original Message ----- From: "Ian Capps" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, September 09, 2003 12:28 AM
Subject: Re: [PEDA] Advanced Schematic on Win2k?




Hi Peter

I have EDA Client 3.0 on WIN 2K without hassles.

Ian Capps








* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to