For the fonts question see this page:
http://www.paulhutch.com/protel_pcb_fonts.htm
This info applies to P99se and earlier, I'm not sure if it applies to DXP.

For putting a bitmap into the PCB there are a few different bitmap to gerber
converter programs out there. I can't remember where to get the programs but
I'm sure someone else on the list will point you to them.

Paul


> -----Original Message-----
> From: William Dager [mailto:[EMAIL PROTECTED]
> Sent: Friday, November 14, 2003 2:44 PM
>
> Hi all,
>
> I am trying to meet the requirements for documentation in our company
> which is that I must have the company logo on all PCB's, and I also need
> to place some non-English characters on the board and its document.
> When I use the <alt>-[number] format, the character shows correctly in
> the popup dialog when placing text, but shows as an entirely different
> and unrelated character when viewing the board.  Help?
>
> Also, does anyone know how to place a graphics file on a PCB document as
> a bitmap, TIF, GIF or other file format?  I need to put the company logo
> on the PCB document, and it seems I can only do it in schematic
> documents.  Does anyone know any tricks whereby I could accomplish this?
>
> I am just a little rusty since it has been two years since I used Protel
> 99SE (and I only used it for 8 months & did not use it to its full
> capabilities), now I am just starting to use DXP and it is a LOT
> different.
>
> Best regards,
>
> William J. Dager
> Senior Engineering Technician
> Neuronetics, Inc.



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to