Hi Adeel, I would select one net and change it to an unused layer, with its own colour, then do the same for the other net.
Although I have always found shorts using a ohm meter on a milli-ohm scale, you can narrow it down to a small area very quickly. Darren Moore > -----Original Message----- > From: Adeel Malik [mailto:[EMAIL PROTECTED] > > > Hi All, > I have a populated board which has two nets shorted > to each other > during assembly. I want to view both of the nets with > different colors in > Protel 99SE PCB document, so that I can locate the potential > areas where the > two nets are in close proximity. > > Can some one tell me how to view the two nets with different > colors to solve > the afore-mentioned problem in Protel 99SE ?> > > Thanks, > ADEEL MALIK * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *