Hi Dean, Sounds like a problem caused by the double click speed for the mouse, have a play with it, control panel, mouse etc...
Darren Moore > -----Original Message----- > From: Carpenter, Dean [mailto:[EMAIL PROTECTED] > > > Hi All - > > OK, this is an odd one ... Recently 99SE started insisting > that I did a double-click on the mouse when starting an > operation. But only for the first time. > > For example, if I do a Reports->Measure-distance, the first > time I click, it dings and pops up with a "Distance = 0mils" > for X and Y, as if I had clicked twice on that one spot. > After that, I can measure properly to my hearts content. ESC > to exit, and do it again, and the exact same thing happens. > > That I can live with. What gets really annoying is when > placing a pad or a via. It almost always puts two down right > on top of each other for the first one. When creating a pcb > library part, I select PAD, then start placing pads. Pad > number 0 and 1 are on top of each other, the others all place > normally. > > It's not the mouse. I've tried several - they all exhibit > the same behavior. And that behavior is a little too > specific to be a hardware issue, it should be happening all > over the place, and in other software. > > -- > Dean Carpenter > Principal Architect > Purdue Pharma > 203-588-7666 > [EMAIL PROTECTED] > 94TT :) * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *