Hello All I had to rework some files in 99SE that I started in 2004. (I wont get into why I had to port these files back to 99SE , because the thread will tie up internet traffic for a week) After completion , I ran my DRC's as usual but the "unrouted net constraint" reported as disabled. I checked, rechecked my rules but the DRCs did not work after exporting back to 99SE. Everything was enabled. Word of warning .... there may be a backward compatibility problem exporting from 2004 to 99SE.
The way I got around it. I copied ALL, pasted it in a new PCB workspace, setup my design rules again. Same board works fine. That's what I did yesterday ....what did you do? Mike Reagan * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *