Mike, Thanks for sharing with us. I really do appreciate YOU having the experience for me.
Joe ----- Original Message ----- From: "Mike Reagan" <[EMAIL PROTECTED]> To: "'Protel EDA Forum'" <[EMAIL PROTECTED]> Sent: Thursday, April 08, 2004 3:14 PM Subject: [PEDA] Saving 2004 to 99SE > Hello All > > I had to rework some files in 99SE that I started in 2004. (I wont get into > why I had to port these files back to 99SE , because the thread will tie up > internet traffic for a week) After completion , I ran my DRC's as usual > but the "unrouted net constraint" reported as disabled. I checked, > rechecked my rules but the DRCs did not work after exporting back to 99SE. > Everything was enabled. Word of warning .... there may be a backward > compatibility problem exporting from 2004 to 99SE. > > The way I got around it. I copied ALL, pasted it in a new PCB workspace, > setup my design rules again. Same board works fine. That's what I did > yesterday ....what did you do? > > > Mike Reagan > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
