Luo,

Were the track and via meant to be connected? If so, then the gerber files
must have been adjusted during the manufacturing. Im not sure if im reading
the problem right.

jjg


-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Sent: Thursday, 13 May 2004 1:12 PM
To: [EMAIL PROTECTED]
Subject: [PEDA] "0 Gap" Means Touch or Not?


Dear Members,

P99SE, The gap between a track and a via is exact 0, DRC does not show this
issue, obviously, It consider the track and the via is connected. Verify the
gerber with IPC-D-356A netlist, also does not find this issue, But on the
finish board, the track and the via is broken. So I got a question as topic,
Does anyone have a good idea to find this problem, except much more
carefulness during design. Thanks.

Best Regards,
Luo.



* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to