In a message dated 2004-05-18 04:00:00 AM Eastern Daylight Time, 
[EMAIL PROTECTED] writes:


> I wanted to change the layer of a segment, which was
> already placed.
> I can get the segment on the other layer but there are
> no vias at both ends.
> 
> Is this the way it works?
> 

Yes, but there's a better way. Go to <tools><preferences> and turn on Remove 
Loops. Then <place><inTeractive routing>, starting on the segment you want to 
flip to the other side. Use the * key to jump to the other side, place tracks 
as needed to where you want to resurface, and use * again to get back. One 
final click and you should see the desired result. Much faster to do that to 
describe.

Steve Hendrix


* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to