Ian We had the same snag and ordered the Bottom windscreen / scuttle bracket ( as seen on Ians Green machine) from QSC recently , (we had asked mark at stoneleigh if he still did them ).
It sits nicely between the uprights on windscreen , and is a good fit on the scuttle , even after removing 5 years worth of silicone sealant ! We had to replace the bottom windscrren seal to a more modest U type , to fit in the bracket. Quite an easy job , for a very big improvement in looks I cant tell you the part number as it was done verbally , but Mark should remember sending an order to dorset for the bracket and a couple of LH wing mirrors!! good luck Rob On 20 June, 19:25, Ian Mac <[email protected]> wrote: > I have been looking at the windscreen that was fitted to my "virtually > ready for IVA" Xtreme. After finding that it was not bonded into the > frame at all, I have found that with the lower rubber removed there is > a gap of approx. 5mm between the scuttle and thr bottom of the > windscreen in the middle. > > Does anyone have any ideas how I can reduce this gap as even with a > new rubber section installed, I am sure that there will still be a gap > once the windscreen is bonded into place within the frame? > > Regards, > > Ian Mac -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
