Hi I too am fitting a mondeo cylinder and servo to my 2+2. I am going to modify the brackets by cutting and welding in a wedge to make the reservoir horizontal. If your car was built using xr2 brakes this is what you need to do as non xr2 fiestas had a completely different arrangement and the servo operating cam is the other way up. As I said in an earlier post there used to be full instructions for the mod on the net but these have now been deleted. I recall there was something about the brake pedal not sitting in the right place unless the brackets were shortened as well as but I could not find anyone to confirm this. On my car I have a lot of wiring for the alarm and ecu sitting in front of the servo brackets and have had to take out the dash to get at the nuts so it is quite a job. I will let you know how I get on.
On Sunday, April 13, 2014 8:41:04 PM UTC+1, Dave the Subbie wrote: > > Hi, I'm trying to locate some parts to rebuild my Mk1 (Q013) and my 2+2 > (the ex-Jon Caton End-to-End one). They are a bit obscure and ebay has faed > me so far. > > Firstly, I cant find the ducting for the dash air vents for the Mk1. It's > a standard XR2 dash and all I need are the two plastic ducts that go from > the heater itself to the fresh-air vents at the far right and left of the > dashboard. > > Secondly, the master cylinder has failed on the 2+2 and it's the late XR2 > type with the inclined servo so I can't get a rebuild kit and I can't find > a new cylinder. > > I have managed to get hold of a non-ABS Mondeo Master cylinder and Servo > and was intending to fit them in place of the old ones, but the brackets > are all wrong. I believe that the earlier XR2 and non-XR2 Mk2 Fiestas had > upright servos and that the Mondeo bits bolt up to their brackets with very > little modification. Basically it is the brackets that hold the servo to > the bulkhead that I need. Although if there is anything else that someone > who has already done this modification knows about, then please let me know. > > If you have, or know of anyone who has, either the ducts or servo brackets > going spare, please just drop me a line on here. I travel a fair bit so may > well be able to pick up or pay postage, etc. > > Thanks, > > Dave > -- -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s). --- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
