John,
Make sure to configure the AV software with the exclusions as follows:
. \RBTI\RBGXE\*.*
. RBENGINE*.dll
. RBGX*.dll
. RStyleX.dll
. OterroX*.dll -- if applicable
. RBENGINE*.cfg
. OterroX*.cfg -- if applicable
. RSyleX.cfg
. Compiledappname.exe
. *.dat
. *.eep
. *.rbc
. *.rbm
. *.rgw
. *.rff
. *.rmd
. *.rx*
Hope it helps!
Very Best R:egards,
Razzak
At 04:38 AM 1/29/2018, John Docherty wrote:
I am running the same application on two
different laptops, both Windows 10 64 Bit,
R:Base XE, one with Bitdefender (old machine)
and the other (new) with Windows Defender. I
find that with the same RX% files on both
machines, the starting screen (an external form)
will be displayed within about 5 seconds on the
old laptop, while on the new one it takes in
excess of 20 seconds. I have the same
configuration settings (as far as I can tell)
and find that this behaviour only happens with
R:Base. With RRBYW19 the start time is about 4
seconds on the old machine and about 24
seconds on the new one. (With CAD files the
newer machine opens files faster than the old
one, as it should.)Â Â I was wondering if
anyone has any suggestions as to what may be
causing this significant difference in
performance. (According to a disc test I ran on
both, the transfer rates on the new laptop are
1500 MB/sec (write) and 3000 MB/sec (read),
while the rates are significantly lower on the old machine - all SSDs.)
Is this likely to be due to the AV software, and
if it is, can I stop WD scanning RX? files
? (I tried installing BD on the new machine
but that created a few blue screens so I gave that idea up.)Â
Any suggestions would be welcome.
--
For group guidelines, visit
http://www.rbase.com/support/usersgroup_guidelines.php
---
You received this message because you are subscribed to the Google Groups "RBASE-L" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
