It is a 1 inch input into the pump. I use a PVC barb fitting and about 6
inches of 1 inch stiff flex tube that hooks to a barb fitting on the pump. I
use a hose clamp on each fitting. What can I do to ensure that it is all
sealed up?? Should I pull the hoses off and use silicone on the barb
fittings then clamp it back down, or does anyone have any other suggestions?
Thanks,
Shane
-----Original Message-----
From: [EMAIL PROTECTED] [SMTP:[EMAIL PROTECTED]]
Sent: Tuesday, April 03, 2001 8:52 AM
To: [EMAIL PROTECTED]
Subject: Re: Tiny Bubbles
On the suction side of the pump it will pull in air from any tiny
leak. On
the pressure side it will spray water!
jeff
________________________________________
LEAVING THE LIST
================
To stop receiving messages you will need to send a message to
[EMAIL PROTECTED] with a command to remove you from the list.
The list manager controls who belongs to the list.
For example:
--------------------------------------------------------------
From: John Doe <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: <not needed>
UNSUBSCRIBE
--------------------------------------------------------------
________________________________________
LEAVING THE LIST
================
To stop receiving messages you will need to send a message to
[EMAIL PROTECTED] with a command to remove you from the list. The list
manager controls who belongs to the list.
For example:
--------------------------------------------------------------
From: John Doe <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: <not needed>
UNSUBSCRIBE
--------------------------------------------------------------
