I think we need a better understanding of your setup. Do you have a sump?
What pump are you using? Is it external? How far under water is your
inlet? Do you have a skimmer? How close is its outlet to your pumps inlet?
Are there lots of bubbles in your sump?
Craig
> It is a 1 inch input into the pump. I use a PVC barb fitting and about 6
> inches of 1 inch stiff flex tube that hooks to a barb fitting on the pump.
I
> use a hose clamp on each fitting. What can I do to ensure that it is all
> sealed up?? Should I pull the hoses off and use silicone on the barb
> fittings then clamp it back down, or does anyone have any other
suggestions?
>
> Thanks,
> Shane
________________________________________
LEAVING THE LIST
================
To stop receiving messages you will need to send a message to
[EMAIL PROTECTED] with a command to remove you from the list. The list
manager controls who belongs to the list.
For example:
--------------------------------------------------------------
From: John Doe <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: <not needed>
UNSUBSCRIBE
--------------------------------------------------------------
