is it possible to actually read 1662 volts AC on a 600 volt digital
meter by putting ground lead of meter on chassis , and the red
one on pin 1 then pin 9 in the ET-60 TX strip , this doesnt seem
possible to me bit i double checked my house current and it read
117 volts , as normal , can some one explain this to me ??? im trying to
chase out the 600 volts to see if i have a voltage problem or if the
8106 / 8156 / 8072 tubes are bad , and again stated the output is
only about 2 watts
and its a 60 watt tx , but lacks 58 watts lol
Russ
N3TIH
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
