Isn't it supposed to be on "DC"???
----- Original Message -----
From: "Ralph Mowery" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Monday, March 15, 2004 9:53 PM
Subject: Re: [Repeater-Builder] Voltage in an Mpro Ge deskmate
>
> > is it possible to actually read 1662 volts AC on a 600 volt
digital
> > meter by putting ground lead of meter on chassis , and the red
> > one on pin 1 then pin 9 in the ET-60 TX strip , this doesnt seem
> > possible to me bit i double checked my house current and it
read
> > 117 volts , as normal , can some one explain this to me ??? im trying
to
> > chase out the 600 volts to see if i have a voltage problem or if
> the
> > 8106 / 8156 / 8072 tubes are bad , and again stated the output
is
> > only about 2 watts
> > and its a 60 watt tx , but lacks 58 watts lol
> >
> > Russ
> > N3TIH
>
> If the voltage is read while transmitting, it is RF getting into the
meter.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
