My suggestion would be to get a telephone line controller that will answer
an incoming call
at your site,  then you can disable the repeater via the phone line until
you can get access.

A company called B&L Electronics in Ottawa, Ill sells these devices.

John VE3AMZ.
----- Original Message -----
From: "rtoplus" <
[EMAIL PROTECTED]>
To: <
[email protected]>
Sent: Thursday, June 10, 2004 3:01 AM
Subject: [Repeater-Builder] stuck repeater


| Greetings from NC at 2:45AM
|
| After arising at about 2:00 AM for a nature call, I noticed on my
| scanner, an un-modulated signal.  I turned on the lights in the
| house to check the channel on the scanner.  Damnit, it's my 2 meter
| repeater!  I don't know how long its been keyed up cause I've been
| sleeping (not anymore tonight).  I attempted to disable the
| controler (zetron model 37) and got all the right response codes but
| the repeater is still chugging right along.  It has a 3 minute
| timeout timer set on the controller and the morse ID is set for 10
| minutes.  Its been about 45 minutes since I've been up and no ID and
| no timeout.  I'm not sure if the repeater (msr2000) has the stock
| timeout timer card still installed or not, I can't remember.  There
| is nothing I can do at this hour as the repeater is a business
| rooftop installation with no access until 10:00AM.  My thoughts are
| that my controller went south cause I can key the repeater and hear
| the courtesy beep when I unkey but I still get no morse ID and also
| I also totally reset the controller to the factory defaults and the
| repeater still stays keyed.  I'm surprised my PA hasn't burned up
| yet...intermittant duty set at about 55 watts.  Any thoughts from
| you folks at what other things I might look for in the AM?
|
|
| Thanks a bunch
|
| Bob, GMRS WPVV845, Amateur KG4WAD, LMRS WPXC892

John J. Riddell,  VE3AMZ
451 Cedarcliffe Dr.,
Waterloo, Ontario, Canada
N2K 2J1








Yahoo! Groups Links

Reply via email to