At 10:17 PM 11/29/04, you wrote:
>Hello to the group,
>I would like to have some information on what type of equiptment that
>I would need to set up a 10 M repeater in the near future.
> I know that it will have to be a split site and most likely have a
>UHF carrier system or a dedicated phone line between sites, but what
>Mod#s of let say GE master2 would I need or is there a better
>solution to the idea. I know its low in the Sun Spot numbers now but
>it wont be forever.
Simplest thing to do is to take a UHF Mastr-Ii and a 10m Mastr-Ii and
swap RX boards. The 406-420 MHz M2s are ideal as a link.
> Thank you for all of your support,
>
> Danny
Please reconsider your decision of adding another repeater
to 10m.....
there are only four repeater channels in the band and they
are unusable now (have you used a scanner recently ???)
and it's the low side of the cycle... it's only going to get
worse as the cycle goes back up...
Years ago you could pick the 10m repeater you wanted to
use by dialing up the appropriate tone. Not any more.
Consider 6m - it's a lot more open and a lot more equipment
available for it. And again - just swap the RX boards in a 6m
and a UHF Mastr-II.
Mike WA6ILQ
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
