--- Kevin & Natalia <[EMAIL PROTECTED]> wrote:
> Hi All,
>
> I need a simple interface for a 600 ohm output radio
> to a controller which accepts 10k ohm.
> This is a RX not TX.
>
> I don't want to make a circuit board if I don't need
> to.
>
> Any ideas?
>
>
Just hang a resistor of about 600 ohms across the
radio output and connect the input to the controller
to it. If you have enough voltage to drive the
controler you do not normally need to worry about
matching the impedances.
__________________________________
Do you Yahoo!?
All your favorites on one personal page � Try My Yahoo!
http://my.yahoo.com
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
