RE: [Repeater-Builder] 600 - 10k ohm Interface

[Richard W. Solomon]

Way back when, we just used a 6 vac fil xfmr. Worked pretty fair as I recall. You can always get fancy later.   73, Dick, W1KSZ -----Original Message----- From: Kevin & Natalia [mailto:[EMAIL PROTECTED] Sent: Sunday, December 12, 2004 6:14 PM To: Repeaters Users Group; Repeater Builder Users Group Subject: [Repeater-Builder] 600 - 10k ohm Interface Hi All,   I need a simple interface for a 600 ohm output radio to a controller which accepts 10k ohm. This is a RX not TX.   I don't want to make a circuit board if I don't need to.   Any ideas?   Regards   Kevin.   Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.