Sounds like it must have been larger than 1/4".
Joe M.
DCFluX wrote:
>
> I've am using the LDF1-50 on my 64 machine. I dont know what the deal
> is but the reducers I was going to run both for both RG-59 and RG-8X
> wouldn't fit this stuff. So I had to just solder the connector
> straight to the cable The center conductor of the cable just fits
> inside the PL-259's. I don't know if RF parts sent me 3/8" by mistake
> or what. But it works about the same as the RG-213 that it replaced.
> I think my duplexer doesn't have enough isolation.
>
> On a related note, I am in the market for a VHF circulator with 3
> connectors (Not 2 and a built in dummy load) preferably SO-239 but I
> will consider N if it can be opened so the connectors can be changed.
>
> On Apr 6, 2005 4:20 PM, Joe <[EMAIL PROTECTED]> wrote:
> >
> > I can't see why you can't use it, even with the PL-259 connectors. My
> > concern was that it is very small in diameter and may suffer damage easily
> > on very long exposed runs.
> >
> > Joe
> >
> > ---- dy3lmk143_13mhz <[EMAIL PROTECTED]> wrote:
> > =============
> > we use this cable for Microwave radios (E1/T1 Radio), and we have
> > about 50 meters excess and I was wondering if it can be use in 2m. I
> > saw its specs it seem its loss was lesser than 9913.
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
>
>
> Yahoo! Groups Links
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
