FYI, Quintron's offsets ran 2 to 6 cycles per transmitter at the most. 20 cycles if getting audible. At 2 to 6 cycles the system sounds pretty good.
Paul -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] Behalf Of Joe Sent: Tuesday, June 07, 2005 5:36 AM To: [email protected] Subject: RE: [Repeater-Builder] Simulcast: Anyone done this for ham repeaters Just keep n mind that you need to have a way to offset each of the transmitters 10-20Hz. You do not want them all on the exact same frequency on an analog simulcast system. If you do have them exactly the same frequency, you will be subject to deep and long phasing nulls in the mixed signal areas. This will sound like signal fade. If you offset the frequencies slightly, these multiple signals will "roll" and create a low frequency beat note. At a 10-20Hz frequency offset, you will never hear a 10-20HZ audio tone on a normal transceiver. Joe ---- Jeff DePolo WN3A <[EMAIL PROTECTED]> wrote: > I have three repeater transmitters running with the rubidium/Delta > combination, but I haven't tackled the audio delay issue yet. The > rubidium/Delta marriage and on-air testing has been more or less just a > proof-of-concept excercise up to this point. When I have more time I'll > get > back to the project. > > --- Jeff Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
