Is there anyone on the list that would like an original Tait T800 manual with the PGM800 software? (on 5-1/4 floppy)
I have one and just about to send it on it's way to the local incinerator. I might be able to transfer software off to 3.5 floppy if someone needs it. Email if interested otherwise it's a goner. Larry - N7FM tait700 wrote: > Hi, > > Was wondering if anyone had any knowledge or experience of any bugs when > burning a new Eprom for one of the above units ? > > I can compose the new .Bin file correctly using PGM800 Win ( i think ) and > send it to the Eprom burner that is telling me when it is finished that it is > copied correctly to the chip ( via Verify ) but when the chip is installed on > the eprom board and fitted to the tx module i have no VCO lock = no transmit. > > I have tried adjusting the VCO trimmer but cannot get it to lock with the new > chip installed. I have added one other frequency to the original one that was > on the original chip ( up exactly 10 mhz ) but it will not lock with either > the original Channel freq or the new one on the new chip. > > The original Chip worked fine with the one that was on there and comparing > the .bin file from this and the new one both look the same when opened with > PGM800. > > I have read the previous posts on this board about creating a new eprom but > if i have done something wrong i cannot see what it is. > > Any info or advice would be much appreciated, > > Unit in question is a T881 850 - 930 mhz > > Regards, > > >