________________________________
From: Larry <la...@thunderbolt.net>
To: Repeater-Builder@yahoogroups.com
Sent: Sun, 9 May, 2010 4:51:50 PM
Subject: Re:[Repeater-Builder] Tait T800 manual and software
May have stated that wrong....
The manual is the "Tait T800 Programming User's guide"
Larry wrote:
Is there anyone on the list that would like an original Tait T800 manual
>with the PGM800 software? (on 5-1/4 floppy)
>
>I have one and just about to send it on it's way to the local incinerator.
>
>I might be able to transfer software off to 3.5 floppy if someone needs it.
>
>Email if interested otherwise it's a goner.
>
>Larry - N7FM
>
>
>
>
>
>
>
>tait700 wrote:
>
>Hi,
>>
>>Was wondering if anyone had any knowledge or experience of any bugs when
>>burning a new Eprom for one of the above units ?
>>
>>I can compose the new .Bin file correctly using PGM800 Win ( i think ) and
>>send it to the Eprom burner that is telling me when it is finished that it is
>>copied correctly to the chip ( via Verify ) but when the chip is installed on
>>the eprom board and fitted to the tx module i have no VCO lock = no transmit.
>>
>>I have tried adjusting the VCO trimmer but cannot get it to lock with the new
>>chip installed. I have added one other frequency to the original one that was
>>on the original chip ( up exactly 10 mhz ) but it will not lock with either
>>the original Channel freq or the new one on the new chip.
>>
>>The original Chip worked fine with the one that was on there and comparing
>>the .bin file from this and the new one both look the same when opened with
>>PGM800.
>>
>>I have read the previous posts on this board about creating a new eprom but
>>if i have done something wrong i cannot see what it is.
>>
>>Any info or advice would be much appreciated,
>>
>>Unit in question is a T881 850 - 930 mhz
>>
>>Regards,
>>
>>
>>
>> gday,id like a copy if ok .regards
l
